“J” and “L” Proceeds …
This morning, we finished off the last two rafters hanging over from yesterdays work. Then we adjusted our Bevel Slicing Machine to the new angle of 57 degrees which is…
“J” and “L” set of Rafters In Progress
For the start of a new week, we start on a new section of the roof. This time, it is the “J” and “L” sections, which are over Bedroom Two…
Roof “B” and “D” Sections Finally Completed
Today, we finally got the eleven rafters up and installed in the Front Extension portion of the building, completing six rafters on the “B” section of the roof and a…
Rafters For “B” and “D” Sections All Bevelled Plus Measurement Made For “J” and “L” Sections
On a very, very chilly day (temperature floating around the low single digits!), we were in the workshop slicing the bevelled ends on our eleven rafters we made yesterday. The…
Eleven Rafters Created for “B” and “D” Roof Sections
After a delayed start, we got on with the creation of the rafters to complete the “B” and “D” roof sections. But first, we filled up our “compressed air” glue …
Some “B” and “D” Rafters Installed and The Rest all Measured and Prepared!
First thing this morning, we took outside the four and a half rafters created yesterday and got them installed up into the roof framework over the front door and Entertainment…
Four and A Half Rafters Created
After a slight delay to the start of the working day, we proceeded with the preparation task for the collection of rafters over the front extension of the roof. We…
Switching to 33degree Roof Slopes Now
For the start of the new week, we start dealing with the 33 degrees angled roof sections, namely the “B”, “D” plus the “J” and “L” sections that makes up…
“E” Section Of Roof Finally Completed
In quite strong winds, we concluded the job of hoisting and installing the remaining rafters to complete the “E” section of the roof. Well, actually, there is an additional bit…
Analysis and Quantifying of Oak Timber for the Facia Boards and Gutters
With the wet weather suddenly dropping on our heads, we went back to the task of analysing and quantifying what we will need to put up a facia board right…