Slicing Slopes on Top of Fascia Boards
Missing our morning’s work session to other duties, we resumed after lunch on the task of slicing a slope on the top edge of our Fascia boards to match the…
Completed Setting Up of Brackets for Fascia Boards
Today, under a superb blue sky and brilliant, very hot sunshine, we continued the task of fixing up support brackets to hold up our Fascia Boards at the exact positions.…
Proceeded With New Liquid Level Device to Get Ready for Fascia Boards
Today, we unpacked our new liquid level device and spent several hours getting it sorted (putting liquid in the 25 metre clear hose, without any bubbles takes time and patience!!),…
Final Black Finishing Coat of Glass Fibre Resin Applied to Downpipe Channels
This morning, we finished off sanding and cleaning up the work we did yesterday on the Downpipe Channels, by removing excess glass fibre here and there and preparing them all…
Glass Fibre Resin Coating for Downpipe Channels
Yesterday and today, we have been preparing and starting the process of putting on a fibre glass resin surface on the insides of the Downpipe Channels. Yesterday, we filled in…
Setting Things in Place for Fascia Boards
A bit of a catch up blog entry for the last few days of work which has been a bit interrupted… We cut the 10 pieces of fascia for the…
Last Three Downpipe Channel’s Made, Corner Eves Cut and Fascia Boards Acquire Bevelled Edges
This blog is a rather long catch-up report of the last few days of work. On Saturday, we made the Sixth Downpipe Channel, this time for the one connecting up…
Fifth Downpipe Channel With Pipe Inserted
A short session only for today. We drilled the large 110mm hole in the Downpipe Channel we made yesterday and fitted the plastic pipe into position. Everything was glued and…
Rubber Membrane Ordered and Fifth Downpipe Channel Created
This morning, we analysed the plans to work out the total length of the rubber membrane we would need for the guttering and the valleys in the roof. There are…
Downpipe Channels Acquire Plastic Pipes
Today, we carried on with the creation of the Downpipe Channels by having a large 110mm diameter hole cut into the base boards at the bottom of the sloping drainage…