“I” Section Is Fully Installed With All Its Rafters!
We tackled the task of completing the “I” section of the roof by installing the eleven rafters we made these last few days. It was a bit of a juggle…
Bevel Ends Sliced in All Rafters for “I” and “E”
This morning, we finished off the task of slicing the bevel ends on all the rafters that are filling in the final gaps in both ‘I’ and ‘E’ sections of…
All “E” Rafters Are Created!
This morning, we finished off the preparation work for the rafters to fill in the “E” section of roof, by slicing the 32 degree ends off all the plywood webbing…
Remaining “I” Rafters Created and Next Section “E” Now Being Organised
Today, this morning, we finished off creating the last five rafters that makes up the “I” section of the roof, to add to the six we made yesterday. we also…
Rafters Created for “I” section
We finished off preparing the parts to make up the rafters to complete the “I” section of the roof this morning. This included cutting the Bird’s mouth into four of…
“M” Section is Complete and Preparation Work Begins for “I” Section
We cut the bevel end on the remaining rafter left-over from yesterday, namely M17. We are still trying to work out why our Bevel Slicing Machine is trying to pull…
M1 through M5 Rafters are Up and Installed
Today we approached the task of slicing the bevelled ends on our nine rafters that are filling in the two triangular gaps in the “M” section of the roof. This…
The Nine Rafters to Finish Off the “M” Section Are Created
Today, we finished off preparing all the parts to build the nine rafters that will fill in the two ends of the “M” section of the roof. The CLS timber…
The Next Nine Rafters Are Being Prepared for the M Section of Roof
This afternoon, we started the task of preparing all the bits and pieces that makes up the nine rafters (five from M1 to M5 and four from M14 to M17)…
Last Two Rafters in this Batch of Eight Is Now Up and Installed
This morning, we took out the last two rafters of the batch of eight we had made this week. They went up just fine. Now we have also measured the…